Why Your Utah Deck Needs Footings (and Why They Have to Go So Deep)
February 10, 2026
A deck looks like it is sitting on top of your yard. In reality, what holds it up is hidden underground. Here is why we dig down about 30 inches before we build, and why we never skip footings.
What is a footing?
A footing is a block of concrete poured in the ground under each deck post. Think of it as the deck’s feet. It does two jobs:
- It spreads the weight. A deck is heavy once you add decking, railings, furniture, a barbecue and a few friends. A wide concrete footing spreads that weight over more soil, so the post does not push down into the ground like a stick in mud.
- It anchors the deck. The post is fixed to something solid, so the deck stays level and steady for years.
Why not just rest the posts on the grass?
Because soil moves. It gets soft when it is wet, and shifts as it dries and freezes. A post sitting on the surface will slowly sink on one side, lean, or wobble. You end up with a bouncy, uneven deck, boards that no longer line up, and in the worst cases a weakened connection where the deck meets your house. That connection is the one safety issue we never compromise on.
The big one: frost
Utah winters are cold enough to freeze the ground. Most soil holds water, and when water freezes it expands, by about 9%. That sounds small, but the force is enough to lift slabs, house foundations and deck posts.
This is called frost heave. The ground freezes, swells, and pushes anything sitting in it upwards. When it thaws, the soil settles back, but rarely in exactly the same place. Do that for a few winters and a shallow footing can end up higher on one corner and lower on another. Your deck twists with it.
So how deep do we go?
The fix is to put the bottom of the footing below the depth the ground freezes to. This is called the frost depth (or frost line). Below it, the soil stays put, so the footing stays put.
The frost depth is set locally, so it changes from place to place. Across Utah, 30 inches is the figure you will see most often. Salt Lake City, for example, lists 30 inches. Logan lists 30 inches for homes. High mountain towns can be deeper, and warm places like St. George can be shallower. We always check with your local building department so we dig to the right number for your address.
How wide should a footing be?
Depth is only half of it. The footing also has to be wide enough for the soil underneath to carry the weight. Typical round footings are somewhere between 12 and 24 inches across. The exact size depends on:
- how much weight lands on that post (bigger decks, hot tubs and covered decks mean more),
- how strong the soil is,
- and what your local building rules say.
A wider base at the bottom also helps grip the ground, which makes it harder for frost to push the footing upwards.
What goes wrong when it is done cheaply
We see the same problems again and again on decks built without proper footings:
- Footings that are too shallow, so they heave every winter
- Footings that are too small, so the deck sinks over time
- Sagging beams and wavy decking
- Loose or damaged connections at the house
The worst part is that none of this shows on day one. A cheap job can look great for a year or two and then start to move.
Do you need a permit?
Yes, always. Every deck footing needs a permit, and a building inspector will usually check the footing holes before any concrete goes in. We handle all of this for you, so you do not need to chase the paperwork.
Another option: helical piles
Concrete is not the only way to hold a deck up. A helical pile is a steel shaft with one or more screw-shaped plates on it, a bit like a giant screw. Instead of digging a hole and pouring concrete, we turn the pile into the ground with a machine until it reaches firm soil below the frost line.
The machine also tells us how hard the ground is pushing back while we turn it. That gives us a good measure of how much weight each pile can carry, so we are not guessing. Because there is no concrete to wait for, a pile can be installed quickly and the deck can go on top straight away. They also cause far less mess and damage to your lawn than digging footing holes.
Are helical piles as good as concrete?
In the right situation, yes, and sometimes better. The screw plates grip the soil well below where it freezes, so frost has little to push against. They work well in wet or soft ground, where a dug hole can fill with water or collapse. They can also go in when the ground is frozen, which means winter builds are possible. And a single pile can carry a lot of weight for its size.
They are not right for every yard. Very rocky ground can stop a pile, and in that case concrete may be the better choice. Concrete footings are also still a proven, familiar choice that every inspector knows well.
The honest answer is that the right footing depends on your soil, your site and your deck. We look at all three before we recommend one. There are several trusted helical pile manufacturers out there, and we choose the one that suits your site best. Either way, it still needs a permit.
Our approach
At Elite Outdoor Pros we dig below the frost line, size every footing for the load it carries, and get the inspection signed off before we pour. It takes more effort at the start, and it is the reason our decks stay flat and solid for years.
Thinking about a new deck, or worried about one that is starting to move? Get a free quote and we will take a look.
Ready to Start Your Project?
Contact our team for a free quote on your outdoor living project.